A quad band PIFA for 4G / 5G wireless communication applications

Authors

  • Amrit Kaur Research Scholar
  • Bikrampal Kaur
  • Ruchi Pasricha
  • Anjali .

Keywords:

PIFA, return loss, 4G, 5G

Abstract

Abstract

A compact PIFA for wireless RF (Radio Frequency) devices is presented. The proposed antenna covers GPS L1, GSM 1800, GSM 1900, UMTS 2100, LTE 1700/2100 MHz, LTE 2300, Bluetooth/Wi-Fi/IEEE 802.11 b/g/n, RFID, IEEE 802.16e mobile WiMAX, UNII and C-band frequency bands useful for both 4G and 5G wireless communication applications. The simulation results for return loss, VSWR, two-dimensional radiation patterns and current distribution are demonstrated. The parametric analysis of feed position in the top patch is also shown and its effects on S11 are examined. The fabricated PIFA results are measured using VNA. The obtained return loss values are less than -10 dB and VSWR values are less than 2.

Keywords: PIFA, return loss, 4G, 5G

Cite this Article

Amrit Kaur, Bikrampal Kaur, Ruchi Pasricha, Anjali. A Quad-Band PIFA for 4G/5G Wireless Communication Applications. Journal of Communication Engineering & Systems. 2019; 9(2): 7–15p.


Author Biography

Amrit Kaur, Research Scholar

ECE Department

References

https://en.wikipedia.org/wiki/List_of_LTE_networks#Asia, internet source, accessed on 20-4-2019

S. Subbaraj, M. Kanagasabai, M. G. N. Alsath, G. Ganesan, Y. P. Selvam, and S. Kingsly, “Compact Multiservice Monopole Antenna for Tablet Devices,” Int. J. Electron., vol. 105, no. 8, 2018.

Weiping Dou and M. Y. W. Chia, “E-shaped planar inverted-F antenna with low-absorption for triple-band operation in cellular phones,” Int. J. Electron., vol. 88, no. 5, pp. 575–585, 2001.

T. Taga and K. Tsunekawa, “Performance Analysis of a Built-In Planar Inverted F Antenna for 800 MHz Band Portable Radio Units,” IEEE J. Sel. Areas Commun., vol. 5, no. 5, pp. 921–929, 1987.

D. M. Nashaat, H. A. Elsadek, and H. Ghali, “Single feed compact quad-band PIFA antenna for wireless communication applications,” IEEE Trans. Antennas Propag., vol. 53, no. 8 II, pp. 2631–2635, 2005.

R. Hossa, A. Byndas, and M. E. Bialkowski, “Improvement of compact terminal antenna performance by incorporating open-end slots in ground plane,” IEEE Microw. Wirel. Components Lett., vol. 14, no. 6, pp. 283–285, 2004.

H. Wong, K. M. Luk, C. H. Chan, Q. Xue, K. K. So, and H. W. Lai, “Small Antennas in Wireless Communications,” Proc. IEEE, vol. 100, no. 7, pp. 2109–2121, 2012.

J. A. Ray and S. R. B. Chaudhuri, “A review of PIFA technology,” IEEE Indian Antenna Week - Work. Adv. Antenna Technol., 2011.

B. . Vijesh.K.R, Hrudya.B.Kurup, P.Mohanan, V.P.N.Nampoori, “A Quad Band Planar Inverted-F Antenna ( PIFA ) with Slotted Ground Plane,” Int. J. Sci. Res. Publ., vol. 4, no. 9, pp. 1–4, 2014.

H. T. Chattha, Y. Huang, Y. Lu, and Z. M. Huang, “A Study of Parameter Changes on the Characteristics of Planar Inverted-F Antenna,” pp. 370–373.

P. S. Hall, E. Lee, and C. T. P. Song, “Planar Inverted-F Antennas,” in Printed Antennas for Wireless Communications, R. Waterho., Chichester, UK: John Wiley & Sons, Ltd, 2007, pp. 195–227.

A. Gundumalla, S. Agrawal, and M. S. Parihar, “International Journal of Electronics and Communications ( AEÜ ) Miniaturized active stepped impedance planar inverted-F antenna using common ground,” AEUE - Int. J. Electron. Commun., vol. 83, pp. 233–239, 2018.

C. Y. Chiu, K. M. Shum, and C. H. Chan, “A tunable via-patch loaded PIFA with size reduction,” IEEE Trans. Antennas Propag., vol. 55, no. 1, pp. 65–71, 2007.

X. Zhang and A. Zhao, “Enhanced-bandwidth PIFA Antenna with a Slot on Ground Plane,” in PIERS Proceedings, 2009, pp. 1268–1272.

A. Cabedo, J. Anguera, C. Picher, M. Ribó, and C. Puente, “Multiband handset antenna combining a PIFA, slots, and ground plane modes,” IEEE Trans. Antennas Propag., vol. 57, no. 9, pp. 2526–2533, 2009.

D.-G. K. D.-G. Kang and Y. Sung, “Compact Hexaband PIFA Antenna for Mobile Handset Applications,” IEEE Antennas Wirel. Propag. Lett., vol. 9, pp. 1127–1130, 2010.

K. J. Kim, S. Lee, B. N. Kim, J. H. Jung, and Y. J. Yoon, “Small antenna with a coupling feed and parasitic elements for multiband mobile applications,” IEEE Antennas Wirel. Propag. Lett., vol. 10, pp. 290–293, 2011.

P. Ciais, R. Staraj, G. Kossiavas, and C. Luxey, “Design of an internal quad-band antenna for mobile phones,” IEEE Microw. Wirel. Components Lett., vol. 14, no. 4, pp. 148–150, 2004.

L. H. Mei, S. S. Ming, Z. Hua, and L. X. Bo, “The effect of slots on PIFA performance,” Proc. 2015 IEEE 4th Asia-Pacific Conf. Antennas Propagation, APCAP 2015, pp. 485–487, 2016.

H. T. Chattha, Y. Huang, M. K. Ishfaq, and S. J. Boyes, “Bandwidth enhancement techniques for planar inverted-F antenna,” IET Microwaves, Antennas Propag., vol. 5, no. 15, p. 1872, 2011.

M. F. Abedin and M. Ali, “Modifying the ground plane and its effect on planar inverted-F antennas (PIFAs) for mobile phone handsets,” IEEE Antennas Wirel. Propag. Lett., vol. 2, pp. 226–229, 2003.

M. et al. Singh, H.S., Agarwal, “A Quad-Band Compact Diversity Antenna for GPS L1/Wi-Fi/LTE2500/WiMAX/HIPERLAN1 Applications,” IEEE Antennas Wirel. Propag. Lett., vol. 13, pp. 249–252, 2014.

A. Verma, D. Punetha, and D. Pant, “A Novel Quad Band Compact Meandered PIFA Antenna for GPS, UMTS, WiMAX, HiperLAN/2 Applications,” in 2015 Second International Conference on Advances in Computing and Communication Engineering, 2015, pp. 404–408.

A. Verma, A. Chauhan, and T. Lal, “Design of Triple Band Compact PIFA Antenna for DCS , PCS , UMTS , 4 G LTE , WiMAX Applications,” IEEE, pp. 4–7, 2015.

M. El Halaoui, A. Kaabal, H. Asselman, S. Ahyoud, and A. Asselman, “Dual Band PIFA for WLAN and WiMAX MIMO Systems for Mobile Handsets,” Procedia Technol., vol. 22, pp. 878–883, 2016.

Z. Zhang, “Introduction,” in Antenna Design for Mobile Devices, John Wiley & Sons (Asia) Pte Ltd, 2011, pp. 1–18.

C. A. Balanis, “Antenna theory: a review,” Proc. IEEE, vol. 80, no. 1, pp. 7–23, 1992.

Downloads

Published

2019-07-18

Issue

Vol. 9 No. 2 (2019)

Section

Articles

License

Declaration and Copyright Transfer Form

(to be completed by authors)

I/ We, the undersigned author(s) of the submitted manuscript, hereby declare, that the above manuscript which is submitted for publication in the STM Journals(s), is not published already in part or whole (except in the form of abstract) in any journal or magazine for private or public circulation, and, is not under consideration of publication elsewhere.

  • I/We will not withdraw the manuscript after 1 week of submission as I have read the Author Guidelines and will adhere to the guidelines.
  • I/We Author(s ) have niether given nor will give this manuscript elsewhere for publishing after submitting in STM Journal(s).
  • I/ We have read the original version of the manuscript and am/ are responsible for the thought contents embodied in it. The work dealt in the manuscript is my/ our own, and my/ our individual contribution to this work is significant enough to qualify for authorship.
  •  I/We also agree to the authorship of the article in the following order:

Author’s name                                    

 

1. ________________

2. ________________

3. ________________

4. ________________

 

We  Author(s) tick this box and would request you to consider it as our signature as we agree to the terms of this Copyright Notice, which will apply to this submission if and when it is published by this journal.